Passengers rushed to provide CPR to woman in plane emergency

Photos via: Joe Marcus, Marty Martinez 

PHILADELPHIA (AP) -- A preliminary examination of the blown jet engine of the Southwest Airlines plane that set off a terrifying chain of events and left a businesswoman hanging half outside a shattered window showed evidence of "metal fatigue," according to the National Transportation Safety Board.

Passengers scrambled to save the woman from getting sucked out the window that had been smashed by debris and a registered nurse and emergency medical technician on the flight rushed to try to help her. She later died, and seven others were injured. 

The pilots of the twin-engine Boeing 737 bound from New York to Dallas with 149 people aboard took it into a rapid descent Tuesday and made an emergency landing in Philadelphia. Oxygen masks dropped from the ceiling and passengers said their prayers and braced for impact. 

"I just remember holding my husband's hand, and we just prayed and prayed and prayed," said passenger Amanda Bourman, of New York. 

The dead woman was identified as Jennifer Riordan, a Wells Fargo bank executive and mother of two from Albuquerque, New Mexico. The seven other victims suffered minor injuries.

MORE: 1 dead after jet blows an engine; woman nearly sucked out | Air traffic audio of Southwest flight during emergency landing

Retired registered nurse Peggy Phillips told a Dallas TV station that she performed CPR on Riordan for about 20 minutes, until the plane landed in Philadelphia.

She said that shortly after takeoff "we heard a loud noise and the plane started shaking like nothing I've ever experienced before. It sounded like the plane was coming apart, and I think we pretty quickly figured out that something happened with the engine."

She said they started losing altitude and the masks came down and "basically I think all of us thought this might be it."

She then heard a lot of commotion a few rows behind her.

"It was a lot of chaos back there -- a lot of really upset people and a lot of noise, and a big rush of air, a big whoosh of air," Phillips said. 

After a flight attendant asked if anyone knew CPR, Phillips and an EMT lay the woman down and performed CPR until the plane was on the ground.

"If you can possibly imagine going through the window of an airplane at about 600 mph and hitting either the fuselage or the wing with your body, with your face, then I think I can probably tell you there was significant trauma," Phillips said.

The National Transportation Safety Board sent a team of investigators to Philadelphia and NTSB chairman Robert Sumwalt said late Tuesday that one of the engine's fan blades was separated and missing. The blade was separated at the point where it would come into the hub and there was evidence of metal fatigue, Sumwalt said.

The engine will be examined further to understand what caused the failure. The investigation is expected to take 12 to 15 months.  

Photos of the plane on the tarmac showed a missing window and a chunk gone from the left engine, including part of its cover. A piece of the engine covering was later found in Bernville, Pennsylvania, about 70 miles west of Philadelphia, Sumwalt said.

As a precaution, Southwest said Tuesday night that it would inspect similar engines in its fleet over the next 30 days.

Passengers praised one of the pilots, Tammie Jo Shults, for her cool-headed handling of the emergency. The former Navy pilot was at the controls when the plane made the emergency landing, according to her husband, Dean Shults. She walked through the aisle and talked with passengers to make sure they were OK after the aircraft touched down.

"She has nerves of steel. That lady, I applaud her," said Alfred Tumlinson, of Corpus Christi, Texas. "I'm going to send her a Christmas card, I'm going to tell you that, with a gift certificate for getting me on the ground. She was awesome."

MORE: Hero pilot of Southwest flight with blown engine was Navy fighter

In a recording of conversations between the cockpit and air traffic controllers, an unidentified female crew member reported that there was a hole in the plane and "someone went out."

Tumlinson said a man in a cowboy hat rushed forward a few rows to grab the woman and pull her back in.

"She was out of the plane. He couldn't do it by himself, so another gentleman came over and helped to get her back in the plane, and they got her," he said.

Southwest CEO Gary Kelly said there were no problems with the plane or its engine when it was inspected on Sunday.

The jet's CFM56-7B engines were made by CFM International, jointly owned by General Electric and Safran Aircraft Engines of France. CFM said in a statement that the CFM56-7B has had "an outstanding safety and reliability record" since its debut in 1997.

MORE: NTSB probes cause of Flight 1380's 'apparent engine failure'

Last year, the engine maker and the Federal Aviation Administration instructed airlines to make ultrasonic inspections of the fan blades of engines like those on the Southwest jet. The FAA said the move was prompted by a report of a fan blade failing and hurling debris. A Southwest spokeswoman said the engine that failed Tuesday was not covered by that directive, but the airline announced it would speed up ultrasonic inspections of fan blades of its CFM56-series engines anyway.

"There's a ring around the engine that is meant to contain the engine pieces when this happens," said John Goglia, a former NTSB member. "In this case it didn't. That's going to be a big focal point for the NTSB -- why didn't (the ring) do its job?"

In 2016, a Southwest Boeing 737-700 blew an engine as it flew from New Orleans to Orlando, Florida, and shrapnel tore a 5-by-16-inch hole just above the wing. The plane landed safely. The NTSB said a fan blade had broken off, apparently because of metal fatigue.